It is known that the suspension is deformed with increasing load mass. In other words, the car/trailer "gives way" and causes the shift of the frame with the wheel axis. By measuring the gap between the frame and the axle, it is possible to accurately measure the load of the vehicle. For these purposes applies the sensor of tilt or movement.

The sensor is attached to the frame of the vehicle and with the help of the mounting kit connects to the axle. Thus using the ALM output signal is processed when you change the angle of the sensor, and hence the output signal.

Set of equipment for spring car:

  • On-Board computer ALM - 1 PC.;
  • Pressure sensor - 2 pieces;
  • Mounting kit - 2 PCs.;
  • Cable - 2 PCs.

If the configuration of the car - hitch (track and semitrailer), used additional coiled cable and a sealed 3 pin plug, for connection of wires from a sensor installed in the trailer, with the cab.